Table of Contents
Advertisement
When the load has reached the selected dryness level,
it will continue to tumble, unheated, during a Cool Down
period. This helps reduce wrinkling and makes items
easier to handle during unloading.
Drying time varies depending on size and dampness of
load and fabric type. Room temperature and humidity,
type of installation and electrical voltage or gas pressure
can also affect drying time.
The following will be displayed during an Auto Dry cycle:
·
The Estimated Drying time for the cycle selected
will be displayed for approximately 5 minutes.
·
The "Ad" is displayed until the Estimated Drying Time
for your specific load has been determined.
·
The cycle status will change from "Auto Dry" to "Cool
Down" while the load is being tumbled without heat.
·
"dn" is displayed when the cycle is done.
·
If the Press Saver option has been selected, the
load will continue to tumble without heat. The cycle
status will change to "Press Saver" and "dn" will be
displayed.
Normal
Select this Auto Dry cycle for cotton items.
Quick
Select this Timed Dry cycle to quickly dry a small load
made up of just a few items. (Auto Dry is not available with
this cycle.)
Towels
Select this Auto Dry cycle for towel loads.
Perm Press
Select this Auto Dry cycle for permanent press items.
Knits / Delicates
Select this Auto Dry cycle for knit and delicate items.
Touch Up
Select Touch Up to help remove wrinkles from clean and
dry items that were not taken from the dryer at the end of
the cycle, have been stored in crowded closets or
drawers, or unpacked from luggage following a trip. It
provides approximately 10 minutes of low heat tumbling
followed by a 5-minute cool down period.
Cycle Adjustments
A suitable drying temperature and dryness level will au-
tomatically be displayed for the cycle selected. To
change settings, press TEMPS and DRYNESS until the
desired selections are made. These adjustments to the
cycle will automatically be remembered each time that
cycle is selected.
Temperature Selection
For best results, follow the fabric care label instructions
on items to be dried. Select the temperature setting most
suitable for each load.
To avoid fire hazard, do not use heat to dry
items containing feathers or down, foam rubber, plastics,
or similarly textured, rubber-like materials. Use the Air
Fluff-No Heat cycle only.
High is recommended for sturdy fabrics.
Medium is recommended for wrinkle free, permanent
press and lightweight fabrics.
Medium-Low is recommended for most knits.
Low is recommended for delicate fabrics.
Note:
To prevent shrinkage, every temperature is
not available with every cycle.
Dryness Selection
Select Normal Dry for most loads.
Occasionally a load may seem too damp or over-dried at
the end of the cycle. To increase drying time for similar
loads in the future, select More Dry. For loads requiring
less drying time, select Less Dry.
Select Damp Dry for items you wish to partially dry
before hanging or ironing. Select the temperature most
suitable for the load.
Note:
To prevent over-drying, every dryness level
is not available with every cycle.
Cycle Options
Press Saver
If the dried load cannot be removed promptly at the end
of the cycle, unheated tumbling continues for approxi-
mately 30 minutes to help reduce wrinkling. When the
signal is selected, it will beep briefly approximately every
15
Hide quick links:
Advertisement
Table of Contents
