Under Counter Installation; Mobile Home Installation - Frigidaire 27" Dryers with electronic controls Service Manual

CLOSET DOOR
0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm)

MOBILE HOME INSTALLATION

1. Dryer MUST be exhausted outside (outdoors, not
beneath the mobile home) using metal ducting that
will not support combustion. Metal ducting must be 4
inches (10.16 cm) in diameter with no obstructions.
Rigid metal duct is preferred.
2. If dryer is exhausted through the floor and area beneath
the mobile home is enclosed, the exhaust system
MUST terminate outside the enclosure with the
termination securely fastened to the mobile home
structure.
3. When installing a gas dryer into a mobile home, a
provision must be made for outside make up air. This
provision is to be not less than twice the area of the
dryer exhaust outlet.
0" (0 cm)
60 SQ. IN.
(387.1 SQ.
60 SQ. IN.
(387.1 SQ. CM)
NOTE: Under counter and stack models - 0 inches (0 cm)
for sides, rear, and top.
0" (0 cm) 0" (0 cm)
0" (0 cm) 0" (0 cm) 0" (0 cm)
15"
(38.1 cm)
4. This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No. 346764 is available from your
dealer.
5. Refer to pages 27 and 28 for other important venting
requirements.
6. Installation MUST conform to current Manufactured Home
Construction & Safety Standard (which is a Federal
Regulation Title 24 CFR-Part 32-80) or when such
standard is not applicable, with American National
Standard for Mobile Homes.
The dryer is designed under ANSI Z
21.5.1or ANSI?UL2158 - CAN/CSA C22.2 (latest editions)
for HOME USE only.
31
1" (2.54 cm)
0" (0 cm)
1" (2.54 cm) 1" (2.54 cm) 1" (2.54 cm)
1" (2.54 cm) 1" (2.54 cm)
0" (0 cm) 0" (0 cm) 0" (0 cm)
0" (0 cm) 0" (0 cm)