Removing the door
Protect fiat work surface, such as top of dryer or
floor near dryer, with a soft cloth or towel.
Open dryer door and remove the two hinge screws.
Remove lower screw first, then upper screw.
Supporting door with both hands, squarely lift door
and hinge upward approximately
3/8" (10 mm) so
"T" post on back of hinge can slide out through "T"
slot on front panel.
"T" SLOT IN
"T" POST ON
Gently place dryer door face down on fiat, covered
Locate the 5 indented head screws (no. 1-5) in
the small, circular recesses (at 11, 1, 4, 6, and 8
o'clock positions) of the inner door. Remove and
save these 5 screws.
Do not attempt to remove the 2 "tamper-resistant"
screws that hold the inner glass !n place: ................................................
Locate the 2 pan head screws (no. 6=7) on the
inner door nearest the metal strike and center of
hinge (9 and 3 o'clock positions). Remove and save
these 2 screws.
Separate inner door assembly from outer door