Install Dryer Support Spacer; Prepare Dryer For Stacking; Stack The Dryer; Washer And Dryer Operation - Frigidaire 27" Dryers with electronic controls Service Manual

3. Install the two (2) front stacking brackets onto the
washer with four (4) screws, provided in the kit. Drive
the screws through the indentations in the plastic
with the tab of the front stacking bracket facing for
ward as shown.
C. Install Dryer Support Spacer
1. On the left side of the washer, remove the screw
and plastic clip toward the front of the washer.
Also, remove the rear screw from the spring retainer.
Save the plastic clip for future side by side use.
Plastic Clip
2. Place the left (L) dryer support spacer onto the left
side of the washer and install with the two (2) screws
that were removed in step C1 and one (1) screw that
was removed in step A1.
3. Repeat steps C1-C2 with the right (R) dryer support
spacer.
Spring Retainer
38
D. Prepare Dryer for Stacking
1. Carefully remove the hole plugs located in the
bottom of the dryer front panel, they will be
reinstalled after stacking. Use a flat blade screw
driver to push out from behind.
2. Remove the four (4) legs from the dryer base. Save
for future side by side use.
E. Stack the Dryer
1. Place the dryer on top of the support spacers. With
the dryer tilted slightly, slide back into the rear
mounting brackets, then lower the front down over
the front stacking brackets.
2. Insert the two (2) long screws, provided in the kit,
through the holes in the dryer front panel and install
into the front stacking brackets.
3. Install the hole plugs removed in step D1.
F. Washer and Dryer Operation
1. Refer to the washer and dryer installation and
operating instructions for proper installation and
operation.