Table of Contents
Advertisement
SECTION G - TEARDOWN
This section will describe how to remove components
from both gas and electric dryer. Unless stated, the pro-
cedure will be the same on all dryers. Unless stated,
reverse the procedure to reinstall the component.
Always remove electrical power from the
dryer when working in an area where electrical power is
present.
Always turn the gas off to the dryer be-
fore opening any gas piping.
Removing the top panel:
1. The top panel is held in place in the front by four
plastic pins and two metal tabs.
Pin
Tab
In the rear by two screws.
2. Remove the two screws, slide the top back about
1/2 inch and lift the top off.
Removing the console drip rail:
1. Remove the top panel.
2. Remove the 2 screws, one at each end, that hold
the rail to the console back panel.
3. Lift the edge of the console and pull the rail back.
Removing the front panel:
1. Disconnect the dryer from electrical supply and
remove the top panel.
2. Unplug the two harness plugs and release the
ground wire.
Page 57
Hide quick links:
Advertisement
Table of Contents
