Changing Engine Oil; Valve Clearance - Parsun F15BM Service Manual

2. If above the upper mark, drain the engine oil; if below lower mark, add engine oil up to upper mark.
CAUTION:
Run the engine and then turn it off, wait for several minutes, and check the engine oil level by the
oil rule again.
If the engine oil still not within the proper level, add/drain as needed.
1. Remove oil level plug, drain plug with washer and gasket; drain off the engine oil.
2. Install new bolt and washer; install drain plug
3. Fill engine oil through oil filler hole.
Engine oil quantity:
Oil type:
4. Install oil level plug.
5. Check engine oil level.
1. Remove stopper hang rope from engine stop switch assy.
Remove spark plug cap from spark plug.
2. Remove starter and belt cover.
3. Remove fuel pump and cylinder cover.
4. Rotate the flywheel clockwise to make the mark "1" on driven pulley align with the mark
the cylinder head.
Check the clearance between the intake and exhaust valves of the upper cylinder. Adjust it if
necessary.
5. Rotate the flywheel clockwise to make the mark "2" on driven pulley align with the mark
the cylinder head.
Check the clearance between the intake and exhaust valves under the lower cylinder. Adjust it if
necessary.
CAUTION

Changing engine oil

1.0 L (Before changing oil filter)
1.2 L (After changing oil filter
API SE, SF, SE-SF, SG-CD SAE 10W30, 10W40

Valve clearance

16
on
on