Leica Roteo 20HV User Manual page 18

D
Symptom
EN The laser's distance is
reduced
F
I
The IR Remote is not working Check for proper operation of the remote.
E
P
NL
DK
The laser's receiver is not
functioning properly.
S
N
Elevation alert function is not
FIN
working
J
CN
Motorized mount will not
ROK
move.
PL
Top four LED's are flashing in
H
sequence.
RUS
CZ
Troubleshooting
Possible Causes and Solutions
Dirt may be reducing the output of the laser.
• Clean the windows of the laser and receiver to improve distance.
• If not the windows, the laser should be returned to an authorized service center
for service.
• Check that the laser is turned on.
• The remote may be outside the usable distance.
• Aim the remote more directly at the laser for maximum distance.
• The remote's battery may be low.
Check for proper operation of the receiver.
• The laser is not rotating. It is leveling or in elevation alert.
• The receiver may be outside the usable distance.
• The remote's battery may be low.
The elevation alert function for the Roteo is normally off until activated by the user.
• Press the H.I. button to activate the H.I. function.
• When turned on, the H.I. LED will flash rapidly (5 Hz), flash slowly when active,
and will turn on solid with an audio alarm when an alert occurs.
Check that the locking knobs {D-1} are tight enough to make contact for the motor.
• Tighten the locking knobs.
• Remove the mount and clean the contacts.
Unit cannot level. Check your set up.
• Unit is tipped beyond self-leveling range.
• Unit is on unstable surface.
15
Roteo 20HV/25H/35/35G - 1.2.0en