SPARK PLUG
CLEAN AND REGAP EVERY 600 HOURS OF OPERATION OR
REPLACE AS NEEDED.
Spark Plug
Nozzle Adaptor
Spark Plug
Figure 15 – Spark Plug Replacement
(For Models CP045CK-CP175DK)
- Remove upper shell (See Air Intake Filter, page 13).
- Remove fan (See Fan Blades).
- Remove ignitor wire from spark plug.
- Remove spark plug from nozzle adaptor using
mediumphillips screwdriver.
- Clean and regap spark plug electrodes to 3.5mm gap.
- Reinstall spark plug to nozzle adaptor.
- Attach ignitor wire to spark plug.
- Reinstall fan and upper shell.
Nozzle Adaptor
Ignitor Wire
Figure 16 – Spark Plug Replacement
(For Model CP210DK only)
- Remove upper shell (See Air Intake Filter, page 13).
- Remove fan (See Fan Blades).
- Remove ignitor wire from spark plug.
- Remove spark plug from nozzle adaptor using mediumphillips screwdriver.
- Clean and regap spark plug electrodes to 3.5mm gap.
- Reinstall spark plug to nozzle adaptor.
- Attach ignitor wire to spark plug.
- Reinstall fan and upper shell.
15
Screw
Ignitor Wire
Spark Plug
Screw
Spark Plug
MAINTENANCE (cont.)
PHOTOCELL
Side Cover
Power
Switch
Screw
PhotocellWire
Bracket
Install Photocell
Incorrect
Correct
Figure 17 – Photocell Replacement
CLEAN PHOTOCELL ANNUALLY OR AS NEEDED.
- Remove upper shell (See Air Intake Filter, page 13)
- Remove fan (See Fan Blades)
- Remove photocell from its mounting bracket.
- Clean photocell lens with cotton swab.
TO REPLACE: Remove side cover near power switch.
- Disconnect wires from power switch and remove
side cover.
- Disconnect wires from circuit board and remove photocell.
- Install new photocell and attach wires to circuit board
- Replace switch wires to power switch and side cover.
- Replace fan and upper shell.
Switch
Wires
Photocell
Lens
.