Nomadix AG 5500 User Manual page 84

For
2. Configurable Ports
Enable or disable administrator access to any of the following interfaces:
3.
Telnet Access
Web Management Access
FTP Access
SFTP Access
SSH Shell Access
Blocking or unblocking interface access will terminate the current session.
Do not enable the blocking of all interfaces without setting up and enabling
SNMP. Enabling the blocking of all interfaces and disabling SNMP will
completely block access to the AG 5500 administration interface. For
assistance, contact Nomadix Technical Support.
Enable or disable subscriber-side interface blocking for any of the following interfaces
4.
Telnet Access
the NSE Telnet interface. Default setting is enabled.
Web Management Access
from the subscriber-side to the NSE WMI. Default setting is enabled.
FTP Access
NSE. Default setting is enabled.
SFTP Access
the NSE. Default setting is enabled.
SSH Shell Access
subscriber-side to the NSE CLI. Default setting is disabled.
Click the check box for
5.
the
Submit
If you enabled Access Control, administrator access is restricted only to the IP addresses
shown under the "Currently Access is Permitted for IPs" listing. If you want to add to or
remove IP addresses from the list, go to Step 4 through Step 8.
The Access Control list can contain up to 50 (fifty) valid administrator IP
addresses or up to 50 (fifty) ranges of IP addresses.
To add an IP address (or range of IP addresses) to the list, enter the "starting" IP address in
6.
the
Access Control Start IP
72
, enter a
: enables/disables blocking of Telnet access from the subscriber-side to
: enables/disables blocking of FTP access from the subscriber-side to the
: enables/disables blocking of SFTP access from the subscriber-side to
: enables/disables blocking of SSH shell access from the
Access Control
button to save your change.
field.
and an
Telnet Port
: enables/disables blocking of Web Management access
if you want to enable this feature, then click on
.
HTTP Port
System Administration
AG 5500