Installation Functions; Installer Setting -E.s.p - LG Single A Svc Manual

4. Installation Functions

4.1 Installer Setting -E.S.P.

What is an E.S.P function?
This is the function that decides the strength of the wind for each wind level and because this function is to make the installation
easier, please do not use this function when using the remote controller.
If you set ESP incorrectly, the air conditioner may malfunction.
This setting must be carried out by a certificated-technician.
This function is used for only Duct product.
Copyright ©2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
1 Press button for 4 seconds
to enter the installer setting
mode until timer segment
display "01:01".
2 Repeat pressing
Function code 03.
Function Code ESP step
3 Set ESP step by pressing
(01: very low, 02: low, 03: medium, 04:
high. 05: power)
4 Move to ESP setting by pressing
button.
5 Press button to select ESP
value(0~255).
- 16 -
button to select
ESP value
button.
LGE Internal Use Only