3.2.10 Trap Event Configuration
The Trap Events Configuration function is used to enable the switch to send out the SNMP trap
information while predefined trap events occurred.
Parameter description:
Trap IP:
IP address of the SNMP trap manager who can receive the traps. Two trap managers
are supported.
System Events:
Warm Start Management operation event
Warm Boot
Cold Boot
Power on event of the switch
Illegal Login
Invalid login event
Port Events:
Link Up
Link Down
Rx error threshold
Tx error threshold
Error threshold
This page also displays occurrence counters of some events.
Port link up event
Port link down event
Rx error over threshold event
Tx error over threshold event
The number of error packets in 5 seconds
-30-