Table of Contents
Advertisement
3.2.5 PVID Configuration
This configuration is applied to Tag-based VLAN mode only.
Parameter description:
Port 1-24 Port number.
PVID
This PVID range will be 1-4094. Before you set a number x as PVID, you have to
create a Tag-based VLAN group with VID x.
Rule 1
Forward only packets with VID matching this port configured VID. You can apply
Rule 1 as a way to a given port to filter unwanted traffic.
Rule 2
Drop untagged frame. You can configure a given port to accept all frames (Tagged and
Untagged) or just receive tagged frame.
Note: If Rule 1 is enabled and port 1, for example, receives an untagged packet, the
switch will apply the PVID of port 1 to tag this packet, the packet then will be for-
warded. But if the PVID of port 1 is not 100, the packet will be dropped.
This is an egress rule of the port. Here you can choose untag or tag. Tag means the
Tag
outgoing packets must carry VLAN tag header, just click the check box. Untag means
the outgoing packets carry no VLAN tag header.
Untag State If you checked this function for a Tag out port, the packet form this port may be tag
out. But, the packet would be untag out if the VID of its tag is the same as the value of
Untag VID while Untag VID state is Enable.
Untag VID Valid range is 0~4094.
-20-
Advertisement
Table of Contents
