Current MLD Configuration
Syntax: show ipv6 mld config
Displays current global MLD configuration for all MLD-
enabled VLANS on the switch.
show ipv6 vlan <vid> config
Displays current MLD configuration for the specified VLAN,
including per-port configuration information.
vid—VLAN ID
For example, the general form of the command might look like this:
ProCurve# show ipv6 mld config
MLD Service Config
Control unknown multicast
Forced fast leave timeout
VLAN ID VLAN NAME
------- --------------- ----------- ---------------
8
VLAN8
9
VLAN9
Figure 7-6. Example of a Global MLD Configuration
The following information, for all MLD-enabled VLANs, is shown:
■
Control unknown multicast: If this is set to YES, any IPv6 multicast
packets that are not joined by an MLD host will be sent only to ports that
have detected a multicast router or ports that are administratively for-
warded. If this is set to NO (or if MLD snooping is disabled), unjoined IPv6
multicast packets will be flooded out all ports in the VLAN.
Forced fast leave timeout: the interval between an address specific query
■
and a forced fast leave (assuming no response), in tenths of seconds
For each VLAN that has MLD enabled:
■
•
VLAN ID and name
•
whether MLD is enabled on the VLAN (default NO, but the VLAN will
not show up on this list unless MLD is enabled)
•
whether the switch can act as querier for the VLAN (default YES)
Multicast Listener Discovery (MLD) Snooping
Displaying MLD Status and Configuration
[Yes] : Yes
[4] : 4
MLD Enabled Querier Allowed
Yes
Yes
Yes
Yes
7-15