HP 8200zl Configuration Manual page 91

ProCurve(config)# show ipv6
Internet (IPv6) Service
IPv6 Routing
Default Gateway : 10.0.9.80
ND DAD
DAD Attempts
Vlan Name
IPv6 Status
Vlan Name
IPv6 Status
Address |
Origin | IPv6 Address/Prefix Length
---------- + ------------------------------------------- -----------
autoconfig | 2620:0:a03:e102::127/64
dhcp | 2620:0:a03:e102:212:79ff:fe88:a100/64
manual | fe80::127/64
Figure 4-1. Example of Show IPv6 Command Output
: Disabled
: Enabled
: 3
: DEFAULT_VLAN
: Disabled
: VLAN10
: Enabled
Syntax: show ipv6 vlan < vid >
Displays IP and IPv6 global configuration settings, the IPv6
status for the specified VLAN, the IPv6 addresses (with prefix
lengths) configured on the specified VLAN, and the expiration
data (Expiry) for each address.:
IPv6 Routing: For software release K.13.01, this setting is
■
always Disabled. (Refer to "Router Access and Default
Router Selection" on page 4-27.).
Default Gateway: Lists the IPv4 default gateway, if any,
■
configured on the switch. This is a globally configured
router gateway address, and is not configured per-VLAN.
ND DAD: Shows whether Neighbor Discovery (ND) is
■
enabled. The default setting is Enabled. Using ipv6 nd dad-
attempts 0 disables neighbor discovery.
IPv6 Addressing Configuration
View the Current IPv6 Addressing Configuration
Address
Status
preferred
preferred
preferred
4-23