HP 8200zl Configuration Manual page 124

IPv6 Management Features
SNMP Management for IPv6
ProCurve(config)# show snmp-server
SNMP Communities
Community Name
-------------------- -------- ------------
public
marker
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Traps Category
----------------------------
SNMP Authentication
Password change
Login failures
Port-Security
Authorization Server Contact
DHCP-Snooping
Dynamic ARP Protection
Address
---------------------- ---------------------- -------- ------ ------- -------
15.29.17.218
15.29.17.219
2620:0000:0260:0211
:0217:a4ff:feff:1f70 marker
Excluded MIBs
Snmp Response Pdu Source-IP Information
Selection Policy
Trap Pdu Source-IP Information
Selection Policy
Figure 5-8. "show snmp-server" Command Output with IPv6 Address
5-22
The show snmp-server command displays the current SNMP policy
configuration, including SNMP communities, network security notifications,
link-change traps, trap receivers (including the IPv4 or IPv6 address) that can
receive SNMPv1 and SNMPv2c traps, and the source IP (interface) address
used in IP headers when sending SNMP notifications (traps and informs) or
responses to SNMP requests.
MIB View Write Access
Manager Unrestricted
Manager Unrestricted
Current Status
---------------
: Extended
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
Community
public
public
: rfc1517
: rfc1517
Events Type Retry
All trap 3
Critical trap 3
Critical trap 3
An IPv6 address is SNMPv2c Inform
displayed on two lines. configuration
Timeout
15
15
15