Bobbin Winding; Placing The Bobbin In The Machine - Husqvarna Viking Platinum 755 User Manual

Learn your Platinum
a

Bobbin Winding

1 Place an empty bobbin on the bobbin
spindle at the front of the machine (the
markafacing up). Push the bobbin
spindle down.
2 Place the large spool holder and a felt
pad under the spool on the auxilary
spool pin.
3 Bring the thread into the thread tension
guide (a), and under thread guide (b)
then over thread guide (c) as illustrated.

Placing the Bobbin in the Machine

Turn off the main switch.
!
1 Remove the bobbin cover by sliding it
towards you.
2 Place the bobbin in the bobbin case with the
markafacing up and the thread to the left
of the bobbin. The bobbin will then rotate
counter clockwise when pulling out the
thread.
3 Place your nger on the bobbin to keep it
from turning as you pull the thread rmly to
the right and then to the left into the tension
spring (a) until it ''clicks'' into place.
4 Continue threading around (b) and to the
right of and then left into the thread cutter
(c). Replace the cover (1). Pull the thread to
the left to cut it (2).
10
c
b
Note: Depending on thread quality, take the
thread one or two turns around the bobbin thread
tension guide (a).
4 From above wind a few turns of thread
clockwise around the bobbin and into
the thread cutter (d).
5 Press the foot control. When the
bobbin is full, the winding will stop
automatically. Remove the bobbin and
cut off the thread. Bring the bobbin
spindle up.
1.
3.
b
d
2.
10 15
4.
b
a
c
2
1