Table of Contents
Advertisement
The Control Cable, 9 conductors, colored coded, 22Awg stranded that connects to the mount with a
twist lock connector is configured in the following manner:
Color Code
Black
*Brown
*Red
Orange
Yellow
Green
Blue
White
**Purple
* The Brown and Red wire perform a dual function when used on a Skewable
(MD500/MD1000/MHDTV/Star Choice) mounts. These wires control the Skew motors when
directed by the Nomad 2 Controller. Applying 12 volt power directly to these wires will skew the
dish.
**The Purple cable is for use on skewable dishes but it WILL NOT effect the operations of a non-
skewable dish when it is connected (or not connected).
The Mount is coil wrapped inside with the following cables and wire:
2 ea
RG179 Teflon coated coax cables (can do four (4) if required)
1 ea
Control Cable, 9 conductor cable, colored coded, 22Awg stranded. This cable is molded
with a twist lock connector on one end and manually terminated at the Nomad 2 end
with a 9 pin connector.
2 or 4 ea RG179 coax cables terminate at the LNB will provide additional cabling for multiple
receivers.
1 ea
Black and White 22Awg stranded wires carry the positive (white) voltage and ground
(black) to the LED which is used to illuminate the dish face.
Technical Support Department at 1-800-247-7486 Ext 338.
WIRING TABLE
Open Face TV Mounts
Pin Designation
1
2
3
4
5
6
7
8
9
For any questions or comments please contact our
Mount
Destination
Motor, Azimuth Positive
Motor, Azimuth/Skew
Negative
Motor, Elevation/Skew
Positive
Motor, Elevation
Negative
Sensor, Count Azimuth
Sensor, Ground
Azimuth/Elevation
Sensor Count Elevation
Power, Mount LED
Sensor, Count Skew
13
Counts
per Degree
3.408
5.034
8.500
Advertisement
Table of Contents
