Table of Contents
Advertisement
Programming Modes
To get into the "Program Mode".....
1. Turn the Nomad power "OFF"
2. Hold both the 'Find' and 'Stow' buttons down and hit the Power
Button "ON"
3. Continue to hold 'Find' and 'Stow' button down for an additional 5
seconds after releasing the Power button
4. Release the 'Find' and 'Stow' buttons at this point and the front
display lights will show the current satellite mode of the unit (Note:
No Lights indicate "Dish Network Non-Skewable mode."
5. Use the 'Find' and 'Stow' buttons to cycle through the light (LED)
patterns until the desired configuration is shown.
6. Turn the 'Power' off to store the programmed settings.
7. When you turn "Power" back on, you can do a Test Dish or "Find"
satellite.
14
Advertisement
Table of Contents
