Table of Contents
Advertisement
This process is only needed to be done once per installation.
CAUTION!! Do not confuse this software with any earlier versions. If you
have a NomadSD.dat file on your SD Card Remove it from the Root Directory
FIRST. Failure to do so will cause your Configuration that is stored on the
NomadSD.dat file to remove any programming that you may do through the
front panel.
The Nomad SD2 Controller can be programmed in simple and easy steps. The
STOW/FIND and the POWER buttons will allow you to configure your
controller properly.
STOW
Entering into the Configuration Mode
• Hold down the STOW and FIND buttons and while continuing to hold,
turn the power on using the POWER ON button. Release the POWER
button but continue to hold the STOW and FIND buttons for an additional
10 seconds or until you see the STOW and FIND LED's turn OFF, then
turn ON again then release. You are now ready to proceed. If that does not
happen, repeat the above process until it does. This will put the controller
into the Configuration mode (similar to what you do or have done with the
Nomad 2/3 Controller to enter into the Programming Mode.)
PROGRAMMING
NOMAD SD2 CONTROLLER
Using the Front Panel
(With Version 29 Software or greater)
NOMAD SD2 CONTROLLER
FIND
11
POWER
Advertisement
Table of Contents
