Table of Contents
Advertisement
• After clicking "OK", In the HyperTerminal window, click FILE, then PROPERTIES, then click
the SETTINGS tab. Click the ASCII SETUP button. Change the LINE DELAY setting from 0, to
100.
YOUR HYPERTERMINAL SETTINGS ARE NOW CONFIGURED
Step 3- Loading software to the Nomad
• TURN ON YOUR CONTROLLER AND PRESS THE * KEY [SHIFT+8] ON THE KEYBOARD,
WITHIN 3 SECONDS AFTER POWERING THE CONTROLLER ON.
IF NOTHING APPEARS YOU HAVE CHOSEN THE WRONG COM PORT-REFER TO THE
HYPERTERMINAL SETUP AND RECONFIGURE
IF YOU SEE 'GAIN ADJUSTED' YOU HAVE TAKEN TOO LONG TO PRESS THE * KEY.
RETRY THE CONTROLLER POWER ON CYCLE AGAIN
24
Advertisement
Table of Contents
