Wiring Examples; A Few Words About Receivers - MotoSAT Nomad 2 Owner's Manual

These diagrams show basic examples of wiring setups between the Mount,
NOMAD Controller, and Satellite TV Receiver. On the left, an MSC60 is wired
through the NOMAD and into a single Star Choice
HD SL-5 is wired to multiple DirecTV
illustrated here will generally apply to all MotoSAT™ TV systems.
EXAMPLE - SINGLE RECEIVER
- MOUNT
CONTROL CABLE
IN FROM MOUNT
PWR
12VCD 4AMP
- NOMAD
OUTPUT
TO SATELLITE TV RECEIVER'S INPUT
- SATELLITE TV RECEIVER
NON-SKEWABLE Open Faced Mounts:
If your satellite receiver is a Dish 500
your home to your RV, you will need to perform a "Check Switch" while
the non-skewable dish is in the STOWED POSITION. Upon completion
of the "Check Switch", your screen should have 8 X's in the check
boxes, meaning that the "Check Switch" failed. This procedure must be
accomplished before you "FIND" satellite. Failure to do so will result in
improper operation of the receiver.
DISH NETWORK
If a Dish Network
Controller and BEFORE the satellite receiver. Failure to do so will result in
improper operation of the satellite receiver.
DirecTV B-BAND CONVERTERS:
©
If a DirecTV B-Band Converter Module (BBC) is used, it must be placed
©
BEFORE the NOMAD. Failure to do so will result in not receiving one of
the Ka Band satellites.
SAMPLE WIRING DIAGRAM
COAXIAL CABLE
IN FROM MOUNT

A FEW WORDS ABOUT RECEIVERS

SEPARATORS:
©
Separator is used, it must be placed AFTER the NOMAD
©
receiver. On the right, an
©
receivers. The basic wiring principles
©
EXAMPLE - MULTIPLE RECEIVERS
- MOUNT
CONTROL CABLE
IN FROM MOUNT
PWR
12VCD 4AMP
- NOMAD
OUTPUT
TO SATELLITE TV RECEIVER'S INPUT
- SATELLITE TV RECEIVERS
or Dish Pro and you remove it from
© ©
COAXIAL CABLE
IN FROM MOUNT
8