Table of Contents
Advertisement
Nomad 1 & Nomad 2
Required Equipment
1.
Computer with 9 Pin Serial Port out (or adaptor).
2.
Special 9-15 Pin Serial Cable (MotoSAT Part # CBL-SERIAL-DATA-10). A special
configured cable that is available only through MotoSAT. Cost $19.00 PS&H.
Overview
Nomad & Nomad 2 Software Update
This procedure outlines how to update the Nomad series controllers via your computer. A few
key things to note are:
*An automatic software upgrade module (MotoSAT Part # Module-Nomad (1) or (2))
is available through MotoSAT if a computer isn't available. This module attaches
directly to the back of the Nomad series controller enabling it to load the new
software. It can be ordered at No Charge. Customer will pay shipping (both ways).
Module must be returned otherwise customer will be billed $65.00 against their Credit
Card. Contact MotoSAT's Tech Support for more information.*
For Any further questions, please contact MotoSAT's Tech Support team at:
Updating the Nomad 1 & Nomad 2 Controller
Step 1-Opening HyperTerminal
• TURN OFF THE NOMAD CONTROLLER
• You now need to start a program on your computer to communicate with the Nomad. This
Program is called HYPERTERMINAL. It can be found by clicking the START BUTTON, then
Software Update
support@motosat.com
21
29 Jun '07
Advertisement
Table of Contents
