Table of Contents
Advertisement
ERROR CODES ARE FLASHING LED LIGHTS AT 1 SECOND INTERVALS
Stow Flashing: This is not an error but indicates the motors are moving.
Find Flashing: Invalid Mode selected, Skewable vs. Non-Skewable.
Find and Stow Flashing: Invalid Mode.
Peak Flashing: Motor Time Out. No counts in Elevation.
Peak and Stow Flashing: Motor Time Out. No counts in Azimuth.
Peak and Find Flashing: Motor Time Out. No counts in Skew.
Peak, Find and Stow Flashing: Limit Error in Elevation movement.
DVB Flashing: Limit Error in Azimuth movement.
DVB and Stow Flashing: Limit Error in Skew movement.
DVB and Peak Flashing: Only Main satellite found.
DVB, Peak and Stow Flashing: Main satellite not found but Secondary satellite was.
DVB, Peak, Find and Stow Flashing: Signal lost, NO LNB Power
Lock Flashing: No satellite found.
Lock and Stow Flashing: Over Temperature on Satellite Receiver.
Lock and Find Flashing: Dish did not raise high enough.
Lock, Find and Stow Flashing: Coax cables on reversed on back of Nomad.
Lock, Peak, Find and Stow Flashing: Could not find main satellite after Skew.
Lock and DVB flashing: EEPROM failure.
Lock, DVB and Stow flashing: AGC Control Failure.
NOTE: Before calling Technical Support please perform a
"Test Dish" and press "Find" one more time before you call.
MotoSAT Customer/Technical Service – (1-800-247-7486 Ext. 338) - Available
Mon-Fri 8:00 a.m. to 5:00 p.m. Mountain Standard Time.
● Please have your MotoSAT Model # and Satellite Receiver Brand
prior to calling Customer/Technical Support.
TROUBLESHOOTING
19
Advertisement
Table of Contents
