Scan View SCANMATE F10 User Manual page 39

Use 2.5-mm Allen
Lamp
key to loosen four
shield
screws in shield
5 • To mount the new lamp/reflector unit, place the top fitting in the
holder in the scanner lid and, gently squeezing both ends of the
reflector so the four holes can engage the four small pins in the
scanner lid, press the bottom fitting into the bottom holder.
CAUTION: Make sure that all four pins have clicked into
the four holes.
CAUTION: Do not touch the inner surface of the reflector!
6 • Place the outer shield in position and retighten the four Allen screws.
The end of the shield with the extensions is the one that
goes toward the front edge of the scanner lid.
7 • Plug in the scanner and turn it on.
8 • Check and, if necessary, realign the lamp assembly as described below.
Lamp/reflector
unit
Squeeze
gently to
release
from
scanner lid
ScanMate F10 • Operator's Manual
Maintenance
6•3