Unpacking The Scanner; Cable Connections; Mains Connection; Scsi Connection: General Rules - Scan View SCANMATE F10 User Manual

Installation

Unpacking the scanner

The scanner must be carefully unpacked and readied for use as explained
in the ScanMate F10 Installation and Repacking Instructions.
CAUTION: The shipping container and other packing materials must be
saved for possible future use. Please note that if the scanner at any future
time needs to be shipped, it must be properly secured and packed as
described in the instructions. Otherwise, the warranty will be invalidated.

Cable connections

MAINS CONNECTION

The ScanMate F10 adjusts automatically to the local voltage.
WARNING: The ScanMate F10 is Class I electrical equipment. It must be
connected to a single-phase mains outlet with a protective ground (earth).
For your personal safety and to avoid damage to the scanner, never connect
the scanner to the mains without a protective ground.
WARNING: The ScanMate F10 is provided with a fuse in the phase only, not
in the neutral. If the scanner is connected to a power system that uses phase-to-
phase connection to achieve one of the specified voltages, make sure the
connection is done in accordance with national and local regulations.

SCSI CONNECTION: GENERAL RULES

The scanner must be connected to the computer with a SCSI cable.
• If no other SCSI units, such as extra hard disks, scanners etc., are connected,
follow the procedure for "Single-Unit SCSI Connection."
• If other units are connected via the computer's SCSI port, follow the in-
structions for "Multiple-Unit SCSI Connection."
CAUTION:
• Before connecting or disconnecting cables, turn off the power for all units in-
2•2
ScanMate F10 • Operator's Manual