Mounting A Template In The Scanner; Template Numbers - Scan View SCANMATE F10 User Manual

MOUNTING A TEMPLATE IN THE SCANNER

ScanView templates are designed to be used with the Bacher Control 2000
registration system, so start by checking that the proper registration pins have
been mounted (see "Registration Pins" under "General Operating Procedures").
Place the template face up on the mounting plate, with the coded end
of the template towards the left-hand side of the scanner. Engage the regi-
stration holes in the forward edge of the template with the corresponding
pins in the scanner frame.

TEMPLATE NUMBERS

The code numbering system at the end of each template is designed for use
with ColorQuartet's high-productivity ScanFlow and MouseFree functions.
Numbering the templates allows ColorQuartet to recognize each tem-
plate. This lets you prepare a batch of scans at one time and then scan it
later: ColorQuartet retrieves all the scan setup data from memory.
• The right-hand line of circles functions as a code for the template type so
the scanner knows which template format is being used.
• The left-hand line of circles is used for custom-numbering the templates
within each type. To select a given number, press out the relevant circle(s).
Examples: for number 1, press out 1; for number 4, press out 1 and 3; for
number 16, press out 1, 5 and 10; and so on.
Circles for
numbering the
individual
templates
1 2 3 5 10 20
5 1 9
6 2
10
Handling originals and mounting plates
Template
identification
code
ScanMate F10 • Operator's Manual
5•5