Using The Registration Pins; Cleaning The Mounting Plate - Scan View SCANMATE F10 User Manual

Place reflection originals face down on the base plate with the top edge
towards the left-hand side of the scanner.
• If you want to be able to view the originals after doing
the preview scan, mount them on the inside surface of
the top plate so they face down when the top plate is
closed. This is easiest to do with the optional
EasyMount mounting table (see below).

USING THE REGISTRATION PINS

Punched films and foils and standard ScanView templates can be placed in
the ScanMate F10 with precise registration by using the registration system
that is built into the scanner tray. Holes and corresponding loose pins are
provided for the most common punch registration systems: Bacher Control
2000, Stoesser, Montaloch, and Beil. Please see "Registration Pins" under
"General Operaing Procedures" for more information.

CLEANING THE MOUNTING PLATE

Scratches and dust are read as information by the scanner. It is therefore
important to keep all surfaces of the mounting plate clean. Cleaning must
be done with care to avoid damaging the glass or the anti-reflection coating.
For cleaning, remove the mounting plate from the scanner.
1 • Carefully remove any pieces of tape that are still attached to the glass.
2 • Use ordinary household glass cleaner or alcohol and a soft, non-abrasive
cloth to clean the top and bottom surfaces of the base plate and top
plate.
3 • After cleaning, wipe all the surfaces with an anti-static cloth to
prevent the build-up of static electricity.
CAUTION:
• Do not use strong organic solvents such as acetone, benzine, etc.
• Do not use any cloth or paper wipes that may scratch the glass.
Handling originals and mounting plates
ScanMate F10 • Operator's Manual
5•3