Led Error Messages; Image Problems - Sim2 CRYSTALCUBE User Manual

LED Error Messages

E C
RROR ODE
System Initial
Ready to Power on (Standby)
System Power on
Lamp Lit , System stable
Cooling
Over Temperature
Thermal Break Sensor error
Lamp Fail
Lamp Temperature shut down
Lamp Short circuit in output detected
Lamp End of lamp life detected
Lamp did not ignite
Lamp extinguished during normal operation
Lamp extinguished during run-up phase
Lamp voltage got error
Lamp ballast got error
Ballast watt value is out of range
(Lamp Normal & Eco mode)
Lamp ballast Communication error
Fan-1 error
Fan-2 error
Fan-3 error
Case Open
DAD1000 error
Color wheel error
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above , please contact your service center.

Image Problems

Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
M
ESSAGES
CRYSTALCUBE—User Manual
P L
OWER ED
G
REEN
Flashing
ON
Flashing
ON
Flashing
ON
4 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
6 blinks
6 blinks
6 blinks
7 blinks
8 blinks
9 blinks
– 41 –
L L
AMP ED
R
ED
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
1 blinks
2 blinks
3 blinks
4 blinks
5 blinks
6 blinks
7 blinks
8 blinks
9 blinks
10 blinks
1 blinks
2 blinks
3 blinks
OFF
OFF
OFF
T L
EMP ED
R
ED
OFF
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF