Throttle Position Sensor; Debris Shields; Accelerator Pedal Removal; Accelerator Pedal Installation - Club Car 2009 Electric Precedent Maintenance And Service Manual

ACCELERATOR AND BRAKE PEDAL GROUP

THROTTLE POSITION SENSOR

The pedal group for the Precedent electric vehicle includes a throttle position sensor mounted on the side of the
accelerator pedal assembly. The throttle position sensor detects the position of the accelerator pedal and sends a
corresponding voltage to the motor controller. The throttle position sensor itself is not intended to be replaced. If sensor
is determined to need replacing through test procedures found in this manual, the accelerator pedal assembly must be
replaced. See Accelerator Pedal Removal on page 5-3.

DEBRIS SHIELDS

Debris shields on the top face of the pedal group prevent excessive debris from contacting the moving parts of
the pedal group. Both shields (4 and 5) are held in place by tabs that snap into the pedal group mounting plate
(Figure 5-3, Page 5-4).

ACCELERATOR PEDAL REMOVAL

1. Remove pedal group from vehicle. See Pedal Group Removal on page 5-1.
2. Remove debris shields (4 and 5) (Figure 5-3, Page 5-4).
3. Remove four screws (13) securing accelerator pedal assembly (9) to pedal group mounting plate and pull
accelerator pedal assembly through bottom of pedal group mounting plate.

ACCELERATOR PEDAL INSTALLATION

1. Insert accelerator pedal assembly (9) through bottom of pedal group mounting plate and secure with four screws
(13) (Figure 5-3, Page 5-4).
2. Tighten screws (13) to 38 in-lb (4.3 N·m)
3. Install debris shields (4 and 5).
4. Install pedal group in vehicle. See Pedal Group Installation on page 5-5.
2009 Electric Precedent Maintenance and Service Manual
5
Pedal Group
Page 5-3