Table of Contents
Advertisement
4. IP500 V2 Installation
This installation process is a simple outline as installation requirements and processes will vary.
· In this process, all the IP Office hardware components are installed and connected without being switched on until
the end of the process. The control unit will then upgrade all the connected components, including phones, to the
appropriate level of firmware.
· Also when switched on, the system is not connected to the customers data network. This ensures that the control
unit will default to known default IP address settings (unless you have pre-loaded the System SD card with a
configuration file with different settings).
Tools and Parts Required
·
Check that you have the tools and additional parts required.
Documentation
·
60
Ensure that you have obtained and read all the relevant documentation.
Unpacking
·
61
Check that all the required equipment has been delivered and that there is no damage.
Install the Base Cards
·
Attach any trunk daughter cards to the IP500 base cards. Insert the cards into the control unit.
Wall Mounting
·
66
If wall mounting, attach the brackets and fit the unit to the wall.
Rack Mounting
·
70
If rack mounting, attach the brackets and fit the control unit into the rack.
Connect External Expansion Modules
·
Connect the external expansions modules to the control unit.
Grounding
·
74
Attach required ground cables to the control unit and external expansion modules.
LAN Network Connections
·
Attach the IP Office control unit and a PC with IP Office Manager to the LAN network.
Starting the System
·
Insert the System SD card and power up the system.
Connecting Phones
·
Connect the Avaya digital phones.
IP Office Basic Edition - Quick Mode Installation
IP Office 8.0
59
62
72
75
76
78
15-601042 Issue 24i (20 December 2011)
Page 58
Advertisement
Table of Contents
