Uwatec Galileo sol User Manual page 69

- in case of an ascent: ascent speed (in
m/min or ft/min) in the position of the
temperature.
Upon pressing the left button (marked SW),
a bookmark will be set while at the same time
the stopwatch is reset. Upon pressing and
holding the left button, you can switch gas
mixtures. The only result of switching gas
mixtures in gauge mode is that the pressure
of the newly chosen tank is displayed instead
of the current one. There are no restrictions
on when a gas switch can take place in gauge
mode. The message SWITCH TO GAS T2
(or TD or T1, whichever is next in sequence)
appears on the display, and the button labels
change to SAVE (left) and >> (middle). Press
or press and hold the left button (SAVE) to
confi rm the switch. Press or press and hold
the middle button (>>) to move to the next tank
in the sequence. Press and hold the right
button to interrupt the gas switch procedure
without carrying out any switch. If the switch is
completed, the message SWITCH TO GAS
T2 (or TD or T1) SUCCESSFUL appears on
the display for 4 seconds.
Upon pressing the middle button (marked
AVG), a bookmark will be set while at the
same time the average depth is reset. Upon
pressing and holding the middle button,
the gas summary table is displayed, followed
by the dive profi le and then the pictures.
3. Diving with Galileo
Upon pressing and holding the right button
(marked LIGHT), the digital compass display
is called up. In addition to the compass
information, this display will also show the
depth and the dive time. Tank pressure and
stopwatch alternate every 4 seconds in the
lower right corner. The stopwatch can again
be reset by pressing the left button.
In compass lay-out display, the middle
button allows you to set a reference bearing
for navigation purposes. A press and hold
will erase the set bearing.
The display will return to the regular gauge
mode display after either the auto-off time or
after a press and hold of the right button.
67