Panasonic KX-FP101AL Service Manual page 88

KX-FP101AL
(25) NUM(BER OF RECORDING MESSAGE
The number of messages recorded in TAM.
(26) NUMBER OF PC SCAN
The number of times multifunction was used for the Scanner. (The number of pages scanned. If the unit does not have a PC
interface, NONE will be printed.)
(27) NUMBER OF PC-PRINT
The number of times multifunction was used for the Printer. (The number of pages printed. If the unit does not have a PC interface,
NONE will be printed.)
(28) NUMBER OF RECEIVING TO PC
The number of times received in the PC through the FAX serial interface (RS232C). (The number of pages received. If the unit does
not have a PC interface, NONE will be printed.)
(29) NUMBER OF SENDING FROM PC
The number of times transmitted from the PC through the FAX serial interface (RS232C). (The number of pages transmitted. If the
unit does not have a PC interface, NONE will be printed.)
(30) NUMBER OF PRINTING WARNING LIST
The number of warning lists printed until now.
(31) NUMBER OF PRINTING HELP
The number of help lists printed until now.
(32) NUMBER OF DIVIDED PRINTING IN FAX RECEPTION
The number of faxes received that were divided into more than one sheet since the unit was purchased.
(33) DETECTION OF RS232C
When the fax and PC serial cable (RS232C) are connected and the signal is received correctly, COMPLETE will be printed. For
models without a PC interface or when there is a PC interface but the signal cannot be received between the fax and PC,
INCOMPLETE will be printed. (The number of pages transmitted. If the unit does not have a PC interface, NONE will be printed.)
(34) Not used
(35) Not used
You may not be able to use IQ-FAX if the special subscriber information is not loaded from the IQ-FAX center before use.
Depending on the conditions of the communication line, it may not be completed in one time, so RETRIED will be performed. The
number of OK and NG IQ-FAX loadings will be printed.
(36) FAX MODE
Means the unit received a fax message in the FAX mode.
(37) MAN RCV
Means the unit received a fax message by manual operation.
(38) FRN RCV
Means the unit received a fax message by friendly signal detection.
(39) VOX
Means the unit detected silence or no voice.
(40) RMT DTMF
Means the unit detected DTMF (Remote Fax activation code) entered remotely.
(41) PAL DTMF
Means the unit detected DTMF (Remote Fax activation code) entered by a parallel connected telephone.
(42) TURN-ON
Means the unit started to receive after 15 rings. (Remote Turn On: Service Code #573)
(43) TIME OUT
Means the unit started to receive after Ring Time Out in the EXT-TAM or TEL/FAX mode.
(44) IDENT
Means the unit detected Ring Detection.
(45) CNG OGM
Means the unit detected the CNG while it was sending the Dummy Ring Back Tone in the TEL/FAX mode, or while answering a
call in the EXT-TAM mode. Or means the unit detected the CNG while it was sending the OGM in the ANS/FAX mode.
(46) CNG ICM
Means the unit detected the CNG while it was recording the ICM in the ANS/FAX mode.
88