Panasonic KX-FP101AL Service Manual page 70

KX-FP101AL
2.3.3.5. Analog Board Section
This chapter provides the testing procedures required for the analog parts. A signal route to be tested is determined depending
upon purposes. For example, the handset TX route begins at the handset microphone and the signal is output to the telephone line.
The signal mainly flowing on this route is analog. You can trace the signal with an oscilloscope. The signal flow on each route is
shown in the Check Sheet here. If you find a specific problem in the unit, for example if you cannot communicate with the H/S, trace
that signal route locally with the following Check Sheet and locate the faulty point.
Note:
{ }: Inside the digital board
70