Panasonic KX-FP101AL Service Manual page 155

Note 1 - Standard facsimile units conforming to T.2 must have the following capability : Index of cooperation (IOC)=264.
Note 2 - Standard facsimile units conforming to T.3 must have the following capability : Index of cooperation (IOC)=264.
Note 1 - Standard facsimile units conforming to T.4 must have the following capability : Paper length=297 mm.
Signal
Training 1
TCF
(Training Check)
CFR X0100001
(Confirmation to Receive)
Training 2
Image Signal Refer to the next page.
RTC
(Return to Control)
EOP X1110100
(End of Procedure)
MCF X0110001
(Message Confirmation)
DCN X1011111
(Disconnect)
MPS X1110010
(Multi-Page Signal)
PRI-EOP X1111100
(Procedural Interrupt-EOP)
PIP X0110101
(Procedural Interrupt Positive)
Identification Signal Format
———————
———————
———————
———————
155
Function
A fixed pattern is transmitted to the receiving side at a speed
(2400 to 9600 bps) designated by DCS, and the receiving side
optimizes the automatic equalizer, etc., according to this signal.
Sends 0 continuously for 1.5 seconds at the same speed as the
training signal.
Notifies the sending side that TCF has been properly received. If
TCF is not properly received, FTT (Failure To Train) X0100010 is
relayed to the sender. The sender then reduces the transmission
speed by one stage and initiates training once again.
Used for reconfirming the receiving side like training 1.
———————
Sends 12 bits (0...01 × 6 times) to the receiver at the same speed
as the image signal and notifies completion of transmission of the
first sheet.
End of one communication
End of 1 page reception
Phase E starts.
Completion of transmission of 1 page. If there are still more
documents to be sent, they are output instead of EOP. After MCF
reception, the sender transmits an image signal of the second
sheet.
If there is an operator call from the sender, it is output after RTC.
This is output when an operator call is received.
KX-FP101AL