Specifying An Output Port; Output Settings For Cameras - JVC VR-N900U Instructions Manual

Specifying an Output Port

A specific event or the clicking of an event button can be
associated with a particular output port.
To do this, specify the output port from which output will be
triggered when a specific event or manual action occurs.
1
Select [I/O Control] in the [Camera Record
Setting] window.
A dialog box will appear.
[I/O Control] window
2
Select the required event from the list in the
left side of the window.
3
Select the required output and click the [
button located below the [Selected Outputs]
list.
To remove an output from the [Selected Outputs] list, select
the required output, and click the [

Output Settings for Cameras

You are able to associate a camera with particular external
outputs, defined in the [I/O Setup] window, for example the
sounding of a siren or the switching on of lights.
The associated outputs can be triggered automatically when
motion is detected as well as manually through output
buttons.
You access the [Output Settings] window from the [Camera
☞
Settings] window ( Page 28), by clicking the [Outputs]
button.
[Output Settings] window
]
] button.
● Selecting Output for Manual Control
You are able to specify outputs to be triggered manually
through output button or from a list in the [Live Viewing]
window.
1
Select the required output in the [All Outputs]
list.
2
Click the [ ] button located between the [All
Outputs] list and the [On Manual Control] list.
• This will copy the selected output to the [On Manual
Control] list.
• You are able to move a selected output up or down in the
[On Manual Control] list with the up and down buttons
located to the right of the list.
• To remove an output from the [On Manual Control] list,
select the required output, and click the [
located between the [All Outputs] list and the [On Manual
Control] list.
● Selecting Output for Use on Motion Detection
You are able to select outputs to be triggered automatically
when motion is detected in images from the camera.
1
Select the required output in the [All Outputs]
list.
2
Click the [ ] button located between the [All
Outputs] list and the [On Motion Detected] list.
• This will copy the selected output to the [On Motion
Detected] list.
• To remove an output from the [On Motion Detected] list,
select the required output, and click the [
located between the [All Outputs] list and the [On Motion
Detected] list.
] button
] button
53