Camera Administration - JVC VR-N900U Instructions Manual

Basic Operation

Camera Administration

1
Select [Camera Record Setting] in the Main Menu.
[Camera Record Administrator] window
2
Select the required camera in the [Device
Manager] section and click the [Settings] button.
The [Camera Settings for Device Name] window will appear.
[Camera Settings for Device Name] window
The [Camera Settings] window lets you set the following
items.
● Speedup Settings
Framerate:
Lets you specify the frame rate acquired from the camera.
It is the frame rate at the time of live viewing and speedup
recording.
CAUTION
• Do not set a value that exceeds camera capacity.
• If the frame rate is not specified for the camera, a frame
rate supported by the camera is set.
● Camera Monitor Setup
Select [Disabled] to disable the camera.
● Audio source
You can select the audio source played back when a
camera is selected in view.
28
● Image storage settings
Desired framerate:
Lets you specify the recording frame rate. You cannot
select a higher value than the [Framerate] specified in the
[Speedup Settings].
CAUTION
• Make sure to set the frame rate so the total rate for all
cameras is displayed view on the [Live Viewing] window at
Settings
60ips (image/sec.) or less for each view.
• The recording frame rate for the system is below 120ips.
Set the total frame rate of all cameras to be below 120ips.
When [Speedup Settings] is used, set the recording frame
rate from the frame rate of [Speedup Settings].
• When images from analog cameras are recorded, set the
total frame rate for analog cameras at 20ips or less.
• Recording frame rate may fall below the setting depending
on the signal processing condition of the VR-N900U.
• Recording frame rate may fall under the following conditions:
-during exports
-when image quality is changed for images displayed
-when total frame rate for images displayed exceeds 60ips
(including images displayed on the computer screen)
• In case of high frame rate settings, the recording frame
rate will measurably increase or decrease.
Speedup:
Lets you specify whether or not to maximize the frame
rate if motion is detected or an event occurs.
Use of speedup on event requires that you define the
events for starting and ending the speedup.
When to store images in database:
Lets you specify the recording conditions in recording
control mode.
When
conditions in the following fields.
Always:
Select the check box to record images at all times.
On motion:
Select check box to store all images in which motion is
detected.
On event:
Select check box to store all images, regardless of
motion, when an event occurs and until another event
occurs, then select required start and stop events in the
[Start] and [Stop] lists.
For details on event setting, refer to "Camera Input/
Output Port and Events". (
Note
• The alarm indicator of front panel lights up when the
motion or event that was set with [When to store images
in database] occur regardless to the recording status. The
alarm indicator will turn off when the [ALARM CLEAR]
button is pressed.
you select [Conditionally],
☞
Page 47)
specify required