Intended use 3. Personal safety a. Stay alert, watch what you are doing and use common Your Black & Decker compact screwdriver has been designed sense when operating a power tool. Do not use a power for screwdriving applications and for drilling in wood, metal tool while you are tired or under the influence of drugs, and plastics.
f. Keep cutting tools sharp and clean. Properly This tool is not intended for use by persons (including maintained cutting tools with sharp cutting edges are less children) with reduced physical, sensory or mental likely to bind and are easier to control. capabilities, or lack of experience and knowledge, unless g.
on the ways in which the tool is used. The vibration level may Use your Black & Decker charger only to charge the increase above the level stated. battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage. When assessing vibration exposure to determine safety Never attempt to charge non-rechargeable batteries.
Assembly Use the spindle lock to loosen very tight screws or to firmly tighten screws. Fitting and removing a drill bit or a screwdriver bit Always hold the tool and screwdriver bit in a straight line (fig. B) with the screw. When screwing in wood, it is recommended to drill a pilot This tool uses screwdriver bits and drill bits with a 6.35 mm hole with a depth equal to the length of the screw.
Regularly clean the motor housing using a damp cloth. Technical data Do not use any abrasive or solvent-based cleaner. KC460LN (H1) Regularly open the chuck and tap it to remove any dust Voltage from the interior (when fitted). No-load speed Hard stall torque Nm 7.7...
The guarantee is valid within the territories of the Member States of KC460LN the European Union and the European Free Trade Area. Black & Decker declares that these products described under "technical data"...
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, Fax 03-9727 5940 Victoria, 3138 New Zealand Black & Decker Tel. +64 9 259 1133 5 Te Apunga Place Fax +64 9 259 1122 Mt Wellington Auckland 1060 United Kingdom Black &...