Intended use Do not force small tools or attachments to do the job of a Your Black & Decker drill/screwdriver has been designed for heavy-duty tool. The tool will do the job better and safer at the screwdriving applications and for drilling in wood, metal and rate for which it was intended.
Page 5
When disposing of batteries, follow the instructions given 7. Charger in the section “Protecting the environment”. 8. Charging base Under extreme conditions, battery leakage may occur. 9. Charger connector When you notice liquid on the battery, proceed as follows: 10. Charger plug - Carefully wipe the liquid off using a cloth.
Page 6
Warning! Do not charge the battery at ambient temperatures Tighten the first screw. below 4 °C or above 40 °C. Recommended charging If the clutch ratchets before the desired result is temperature: approx. 24 °C. achieved, increase the collar setting and continue tightening the screw.
Technical data Warning! Before performing any maintenance on the tool, remove the battery from the tool. Unplug the charger before AST12 AST2 KC96 KC12 KC14 cleaning it. Voltage No-load speed Regularly clean the ventilation slots in your tool using a Max.
Page 8
To claim on the guarantee, you will need to submit proof of Australia WALT Industrial Power Tool Company purchase to the seller or an authorised repair agent. You can 7 Clarice Road Tel. 03 9895 9200 check the location of your nearest authorised repair agent by Box Hill, Victoria 3128 Fax 03 9899 7465 contacting your local Black &...