Dbs Receiver Brand Setting - JVC HM-DH40000U Instructions Manual

70
EN
DBS Receiver
Brand Setting
2
VCR
CABLE
TV /DBS
3 4
- 2
Number keys
DBS BRAND NAME
JVC (DISH Network)
ECHOSTAR (DISH Network)
SONY (DSS)
RCA (DSS)
MULTI-BRAND REMOTE CONTROL (cont.)
3
- 1,3
4
4
TV/VCR
CH +/–
ENTER
3
- 3
BRAND CODE
51
51
41
40
When programed (set) with a manufacturer's (brand's)
code, this Remote can perform some of the remote
control functions of the listed DBS (Direct Broadcast
Satellite) receivers.
1
Turn on the DBS receiver
Turn on the DBS receiver using the Power button
on the DBS receiver or its Remote.
2
Set remote operation mode
Set the VCR/TV/CABLE/DBS selector to "CABLE/
DBS".
3
Enter DBS receiver brand code
Follow the example shown below.
1 Press and hold POWER.
2 Press the Number keys to enter your DBS
receiver's brand code by referring to the table
below.
3 Press STOP ( 7 ), and release POWER.
Once you have set the Remote to operate a
DBS receiver, you do not have to set it again
until you replace the Remote's batteries.
4
Operate DBS receiver
Press one of the following buttons: POWER, TV/
VCR CH +/–, and Number keys.
For some brands, you must press ENTER after
having pressed the Number keys to enter a
channel number.
To change the DBS receiver's channels, press
TV/VCR CH +/– or the Number keys.
To operate the VCR, set the VCR/TV/CABLE/
DBS selector back to "VCR".
NOTES:
Depending on the type of DBS receiver, some or all functions
cannot be operated using this Remote.
It is impossible to control a DBS receiver that does not have a
remote sensor.
It's not possible to set the Remote for both your DBS receiver
and a cable box at the same time. You can only set the
Remote to operate one of these units at a time.
(Ex.) To set the Remote to JVC 51:
POWER
JKL
Hold
Press in succession
down
STOP
. , ?
Release