Setting Dbs Receiver Input Channel & Brand; Turn On The Vcr - JVC HM-DH40000U Instructions Manual

Turn on the VCR and the TV, and select the AV
mode on the TV.
Set the VCR/TV/CABLE/DBS selector on the
Remote to "VCR".
VCR
CABLE
TV /DBS
2
Setting DBS receiver input
channel & brand
After installation, set the DBS receiver's input channel
and its brand correctly; otherwise, the Controller cannot
work correctly.
1
2
3
4
3 4
Turn on DBS receiver
Select a channel other than channel 100 or 205
on your DBS receiver.
Access Main Menu screen on VCR
Press MENU.
Access DBS Receiver Set screen
1 Press @ # to move
the arrow to
"TUNER SET UP",
then press fi or
OK.
2 Press @ # to move
the arrow to "DBS
SET UP", then
press fi or OK.
Select DBS receiver input channel
Press %fi to move
the arrow to
"INPUT CH".
Your selection
depends on how
your DBS receiver
is connected to
your VCR.
If your DBS receiver is connected to your
VCR's ANTENNA IN terminal on the rear
panel
Press @ # until the channel number
representing the DBS receiver's output (ON
CH3 or ON CH4) appears on the screen.
If your DBS receiver is connected to your VCR's
AUDIO/VIDEO IN connectors on the front panel
Press @ # until "ON F-1" appears on the
screen.
If your DBS receiver is connected to your VCR's
AUDIO/VIDEO IN (L-1) or AUDIO/VIDEO IN
(L-2) connectors on the rear panel
Press @ # until "ON L-1" or "ON L-2" appears
on the screen.
If you do not use a DBS receiver
Press @ # until "OFF" appears on the screen.
CONTINUED ON NEXT PAGE \
19
EN
FUNCTION SET UP TUNER SET UP INITIAL SET UP
TUNER SET CABLE SET UP DBS SET UP
INPUT CH OFF
40
BRAND
TEST MODE
OK
MENU
SELECT WITH ARROW KEYS
THEN PRESS [OK]
EXIT SELECT
FUNCTION SET UP TUNER SET UP INITIAL SET UP
DBS SET UP
INPUT CH
OFF
BRAND 40
TEST MODE
OK
MENU
SELECT WITH ARROW KEYS
THEN PRESS [OK]
EXIT SELECT