Tuner Set - JVC DR-MV5BEK Instructions Manual

Filename [MV5SEK_13Subsidiary.fm]
MV5SEK_00.book Page 84 Wednesday, August 31, 2005 7:58 PM
SUBSIDIARY SETTINGS
84
EN

Tuner Set

Your unit needs to memorise all necessary stations in channel
positions in order to record TV programmes. Auto Channel Set
automatically assigns all receivable stations in your area to call
them up by using the PR +/– buttons without going through any
vacant channels.
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/DVD switch to DVD.
VHS
ENTER
IMPORTANT:
Perform the following steps only if —
— Auto Channel Set has not been set correctly by Auto Set Up
or by Preset Download. ( pg. 17, 18)
— you have moved to a different area or if a new station starts
broadcasting in your area.
Page 84Wednesday, 31 August 2005 19:58
Auto Channel Set
1
Press SET UP to access the Main Menu screen.
2
Press w e to select "INITIAL SET UP", then press t.
3
Press w e to select "AUTO CH SET", then press ENTER.
When you have connected the unit to a TV offering T-V Link via a
fully-wired 21-pin SCART cable (
performs the Preset Download and the T-V LINK screen will appear.
( pg. 18)
The Auto Set screen appears, and remains on screen while the unit
searches for receivable stations.
Wait until the TV screen as shown in step 4 appears.
4
View the Confirmation screen.
"SCAN COMPLETED" is displayed on the TV screen. Press "OK".
5
Press SET UP to complete the setting.
When Auto Channel Set is completed, "PLEASE WAIT" will be
displayed for about 90 seconds, since channel data is exchanged
between the DVD deck and the VHS deck. No operations will be
done during this time.
Using the Confirmation screen, you can skip or add channel
positions, enter station names and perform other operations. Refer to
pages 85 – 87 for the procedures.
Depending on reception conditions, the stations may not be stored in
order, and the station names may not be stored correctly.
IMPORTANT:
In certain reception conditions, station names may not be stored
correctly, and Auto Guide Program Number Set may not work
properly. When the Guide Program numbers are not set properly,
the programme that you do not intended to record will be timer-
recorded by the VIDEO Plus+ system of the unit. When
programming the timer using the VIDEO Plus+ system, be sure to
check the desired channel is selected correctly. (
Your unit memorises all receivable stations even if reception of
some of them is poor. You can delete those stations with an
unacceptable picture from the list. (
NOTES:
Fine tuning is performed automatically during Auto Channel Set. If
you want to perform tuning manually, refer to "Fine-Tuning Channels
Already Stored" (
If you perform Auto Channel Set when the aerial cable is not
SET UP
connected properly, "SCAN COMPLETED –NO SIGNAL–" appears
on the TV screen in step 4. In such a case, make sure of the aerial
connection and press ENTER; Auto Channel Set will start again.
Masterpage:Left+
pg. 15), the unit automatically
pg. 86, "Delete A Channel")
pg. 87).
pg. 29)