JVC DR-MV5BEK Instructions Manual page 38

Filename [MV5SEK_08Basic TimerDub.fm]
MV5SEK_00.book Page 38 Wednesday, August 31, 2005 7:58 PM
EDITING
38
EN
Manual Dubbing (From VHS To DVD)
Dubbing A Part Of A Cassette
You can dub the selected scenes on a tape to the DVD disc,
starting and stopping wherever you wish.
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/DVD switch to DVD.
Make sure that both the DVD deck and the VHS deck are in the
stop mode.
VHS
STANDBY/ON
S-VIDEO VIDEO AUDIO
VHS
REC MODE
Page 38Wednesday, 31 August 2005 19:58
DVD REC
PR
VHS/DVD
VHS DUBBING DVD
DV IN
VHS/DVD VHS DUBBING
DVD
Masterpage:Left+
1
For DVD deck
Load a recordable disc.
For VHS deck
Load a cassette you want to dub.
2
Press VHS] to select the dubbing direction.
"]" lights up on the unit.
3
Set "VHS]DVD DUBBING" to "1 PROG". (
4
Prepare the VHS deck for dubbing.
A Press VHS/DVD on the unit repeatedly or VHS on the remote
control so that the VHS lamp lights up on the unit.
B Locate the point from where you want to start dubbing, then
pause playback.
During still picture on the VHS deck, the images may jitter, but this is
not a malfunction.
5
Prepare the DVD deck for dubbing.
A Press VHS/DVD on the unit repeatedly or DVD on the remote
control so that the DVD lamp lights up on the unit.
B Press REC MODE repeatedly to set the recording mode.
C Press and hold 7, then press 9 so that the DVD deck enters
the Record Pause mode.
6
Press and hold DUBBING for more than 2 seconds to start
dubbing.
7
Press 8 to stop recording on the DVD deck.
Both the VHS deck and the DVD deck are stopped.
After dubbing is completed, press VHS] so that "]" lights off. If it is
not done, recording on the DVD deck is not possible.
NOTES:
It is not possible to dub a tape with a copy protection signal.
If there is no remaining recording time left on a DVD disc, the tape
automatically stops at that position.
It is not possible to perform other operations like Live Memory
Playback. Check the recorded programme on the disc after dubbing.
pg. 81)