JVC DR-MV5BEK Instructions Manual page 63

Filename [MV5SEK_09Advanced Operation.fm]
MV5SEK_00.book Page 63 Wednesday, August 31, 2005 7:58 PM
Advanced Recording (VHS)
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/DVD switch to DVD.
Press VHS so that the VHS lamp lights up on the unit.
VHS
STANDBY/ON
S-VIDEO VIDEO AUDIO
VHS
0000
DISPLAY
Page 63Wednesday, 31 August 2005 19:58
DVD REC
PR
VHS/DVD
VHS DUBBING DVD
DV IN
TV/VIDEO
PR +/–
Masterpage:Right+
Accidental erasure prevention
To prevent accidental recording on
a recorded cassette, remove its
safety tab. To record on it later,
cover the hole with adhesive tape.
Record safety tab
Watch Another Programme While Recording On The Unit
While recording is going on, you can watch another programme on
the TV by using the TV's tuner.
NOTE:
It is required that the remote control is set to be able to operate the TV
in advance. ( pg. 75)
1
During recording, press TV/VIDEO to switch the TV's input
mode so that the programme selected on the TV appears.
2
Slide the TV/DVD switch to TV.
3
Press PR +/– repeatedly to select the desired channel.
NOTE:
If a decoder is connected to the unit (
scrambled channel as well as other normal channels.
Instant Timer Recording (ITR)
This easy method lets you record for from 30 minutes to 6 hours
(selectable in 30-minutes interval), and shuts the unit off after
recording is finished.
1
Press 7 on the unit to start recording.
2
Press 7 again to engage the ITR mode.
On the front display panel, "0:30" appears.
3
If you want to record for more than 30 minutes, press 7 to
extend the time. Each press extends recording time by 30 minutes.
NOTES:
You can only perform ITR using the 7 button on the unit.
During Instant Timer Recording, any other timer programmed
recording won't start even if their start time has come. In such a case,
the timer programmed recording starts (if the end time of the timer
programmed recording is set after the end of Instant Timer
Recording) after the Instant Timer Recording finishes.
Elapsed Recording Time Indication
1
Press DISPLAY until a counter reading appears on the front
display panel.
2
Press 0000 to reset the counter before starting recording or
playback.
The counter is reset to "0:00:00" and shows the exact elapsed time
as the tape runs. You can check the exact time of a recording or
playback.
ADVANCED RECORDING
63
EN
pg. 76), you can select a