Table of Contents
Advertisement
Filename [MV5SEK_05Name.fm]
MV5SEK_00.book Page 16 Wednesday, August 31, 2005 7:58 PM
GET OVER IT! – CONNECTIONS –
16
EN
Component Video Connection (DVD deck only)
Back of TV
Aerial connector
Component video input connectors
Component video cable
(not provided)
AC power cord
Back of unit
AC outlet
Page 16
RF cable
TV aerial cable
(provided)
ANTENNA IN
COMPONENT VIDEO OUT
ANTENNA OUT
ATTENTION:
Your TV also must have a component video input
connectors for the connection to the unit.
1
Perform 1 – 3 in "Composite Connection"
(
pg. 15).
2
Connect the unit's [COMPONENT VIDEO OUT]
connectors to the TV's component video input
connectors.
3
Connect the unit's [AUDIO OUT] connectors to the
TV's AUDIO input connectors.
You can obtain high-quality component video pictures.
If your TV is not stereo-capable, use the unit's [AUDIO
OUT] connectors to connect to an audio amplifier for Hi-Fi
stereo sound reproduction.
By using the component video connection, you can view
the images in the progressive mode. For switching to the
progressive mode, refer to "Scan Mode Set" (
4
Plug the end of the AC power cord into an AC outlet.
"LOADING" blinks on the front display panel when the AC
plug of the power cord is connected into an AC outlet and
no operation will be done for approximately 50 seconds.
This is not a malfunction.
After connection is completed, perform "Auto Set Up" on
page 17.
Wednesday, 31 August 2005 19:58
Masterpage:Left+
pg. 80).
Hide quick links:
Advertisement
Table of Contents
