System Connections; Connecting To A Satellite Receiver - JVC DR-M1SLB Instructions Manual

90

Connecting To A Satellite Receiver

Connect the satellite receiver to the L-2 IN/DECODER connector, then connect the L-1 IN/OUT connector to the TV's
connector.
NOTES:
Set "L-2 SELECT" to "VIDEO" or "S-VIDEO". (
You can use the Automatic Satellite Programme Recording function (
To record a programme via the satellite receiver, select L-2 mode by pressing PR +/– so that "L-2" appears on the front display panel.
For details, refer to the instruction manual of the satellite receiver.
Satellite receiver
IMPORTANT:
When you set "L-2 SELECT" to "SAT VIDEO" or "SAT S-VIDEO" (
a satellite broadcast with the TV set to its AV mode even if the unit is turned off. When the unit is in Stop mode or recording, press
on the remote control to turn off the VIDEO indicator on the unit.
If you turn on the unit when the satellite receiver's power is off, nothing appears on the TV screen. In this case, turn on the
satellite receiver, or set the TV to its TV mode, or press
pg. 85)
Aerial
Outdoor unit
Satellite cable
pg. 65) with this connection.
Aerial connector
TV aerial cable
ANTENNA IN
ANTENNA OUT
21-pin SCART connector
Back of unit
pg. 85, "L-2 Select Setting (L-2 SELECT)"), it is possible to view
on the remote control to set the unit to the AV mode.

SYSTEM CONNECTIONS

Back of TV
Mains outlet