Edit To Or From Another Recorder - JVC DR-M1SLB Instructions Manual

Edit To Or From
Another Recorder
TV receiver
Player
21-pin SCART cable
(not provided)
Recorder
TV receiver
Recorder
21-pin SCART cable
(not provided)
Player
Your unit
21-pin SCART cable
(provided)
Another recorder
Your unit
21-pin SCART cable
(provided)
Another recorder
You can use your unit as the source player or as the
recording deck.
Slide the TV/CABLE/SAT/DVD switch to DVD.
A
Make connections.
Connect the player's 21-pin SCART connector to the
unit's 21-pin SCART connector as illustrated.
A When using your unit as the source player:
— connect its L-1 IN/OUT connector to the recording
deck.
B When using your unit as the recording deck:
— connect its L-1 IN/OUT or L-2 IN/DECODER
connector to the source player.
If another recorder is compatible with the Y/C signal:
— when using your unit as the source player, set "L-1
OUTPUT" to "SCART S-VIDEO". (
L-1 Input Setting (L-1 OUTPUT and L-1 INPUT)")
— when using your unit as the recording deck, set "L-2
SELECT" to "S-VIDEO". (
(L-2 SELECT)")
B
Set the input mode of recording deck.
With this unit, press PR +/– to select "L-1" for the L-1 IN/
OUT connector, or "L-2" for the L-2 IN/DECODER
connector, depending on the connector being used.
When using another recorder as the recording deck, refer to its
instruction manual.
When using the L-2 IN/DECODER connector, set "L-2
SELECT" to "VIDEO" or "S-VIDEO". (
Setting (L-2 SELECT)")
C
Set the recording speed.
Press REC MODE repeatedly until the desired recording
speed appears.
D
Start the source player.
Engage the Play mode of the source player.
E
Start the recording deck.
Engage the Record mode of the recording deck.
F
Stop dubbing.
Stop recording on the recording deck, then stop playback
on the source player.
NOTES:
All necessary cables can be obtained from your dealer.
For Y/C signal input/output, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.
When you use this unit as the source player for editing, be sure
to set "SUPERIMPOSE" to "OFF" before starting. (
If you are using another recorder with S-Video and Audio
output connectors, connect its S-Video and Audio output
connectors to this unit's S-VIDEO and AUDIO input
connectors on the front panel. Then, set the unit's input mode
to "F-1" in step B, and set "F-1 INPUT" to "S-VIDEO".
( pg. 85, "F-1 Input Setting (F-1 INPUT)")
pg. 84, "L-1 Output and
pg. 85, "L-2 Select Setting
pg. 85, "L-2 Select
pg. 95)
83