Table of Contents
Advertisement
REMOTE CONTROL
Remote Control
Functions
Remote 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four
codes (1, 2, 3 or 4). The remote control is preset to send 1 code
signals because your unit is initially set to respond to 1 code
signals. You can easily modify your unit to respond to 2, 3 or 4
code signals.
Slide the TV/CABLE/SAT/DVD switch to DVD.
On the remote control
Keep pressing SET UP down during steps A – B.
A
Change the remote control code.
Press the number key "1" for 1, "2" for 2, "3" for 3 or
"4" for 4.
B
Set the remote control code.
Press ENTER to set the code.
On the unit
C
Turn off the unit.
Press 1 on the unit.
D
Display the code.
Press 4 on the unit for over 5 seconds while the unit is
turned off.
The code currently set appears on the front display panel.
E
Change the unit's code.
Press 8 on the remote control.
The code currently set on the remote control blinks on the
front display panel for approximately 5 seconds, and is
applied to the unit.
NOTE:
When "POWER SAVE" is set to "ON" (
possible to change the remote code.
87
pg. 95), it is not
Advertisement
Table of Contents
