Table of Contents
Advertisement
82
Edit From A
Camcorder
A
If the camcorder has no S-VIDEO output connector:
Recorder
Video cable (not provided)
VIDEO OUT
Camcorder
AUDIO OUT
Player
B
If the camcorder has an S-VIDEO output connector:
Recorder
S-Video cable (not provided)
S-VIDEO OUT
Camcorder
AUDIO OUT
Player
AUDIO input
VIDEO input
Audio cable (not provided)
AUDIO input
S-VIDEO input
Audio cable (not provided)
You can use a camcorder as the source player and your
unit as the recording deck.
Slide the TV/CABLE/SAT/DVD switch to DVD.
A
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and VIDEO
OUT connectors to the unit's AUDIO and VIDEO
input connectors on the front panel.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and
S-VIDEO OUT connectors to the unit's AUDIO and
S-VIDEO input connectors on the front panel.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
B
Set the unit's input mode.
Press PR +/– to set the channel to "F-1".
Set "F-1 INPUT" to "VIDEO" for the VIDEO input connector,
or "S-VIDEO" for the S-VIDEO input connector, depending on
the connector being used. (
(F-1 INPUT)")
C
Set the recording speed.
Press REC MODE repeatedly until the desired recording
speed appears.
D
Prepare the camcorder for dubbing.
Start playback on the camcorder slightly before the actual
point from where you wish to start dubbing.
E
Start dubbing.
Press and hold 7, then press 4 on the remote control, or
press 7 on the unit.
F
Stop dubbing.
Press 8 on the unit, then stop playback on the
camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorder's instruction manual for operating
procedure.
The quality of dubbed picture becomes poorer than that of the
original.
EDITING (cont.)
pg. 85, "F-1 Input Setting
Advertisement
Table of Contents
