Configure The Next Handset To The Base Station - Nortel T7406 Installation Manual

20 Chapter 1 About your T7406 Phone
11 Within 15 seconds, press and hold the
to the base station. The display shows
successful.
12 If the Security Code transfer fails, the display shows
and 10.
13 Press the Options button to exit the Option menu.
The display changes to show the date and time.

Configure the next handset to the base station

Configure the second and third handsets to the base station using these procedures:
1
Follow the steps in
different handset ID number (1, 2, or 3) for each handset you configure.
2 If you want to change the handset ID password, continue with the steps in
Handset ID Password" on page
3 Once you have assigned a Handset ID #, continue with
19 up to and including step 8
To configure the next handset:
1 Find out the existing Security Code of the base from your installer.
2 Press the Options button.
SHOW
3 Press
The display shows
SHOW
4 Press
The display shows
5 Enter a six-digit Security code.
The display changes to show the code as entered.
6 OK
Press to accept the code.
7 NEXT
Press
SHOW
8 Press
The display shows
1 2
9 Press ,
OK
10 Press to accept the handset configuration.
11 Press the Options button.
The display changes to show the date and time.
P0606142
"Configuring the Handset ID Number" on page
18.
.
1. Set S.S. Code :
.
Press 6 digits
until the display shows
.
Press Digits 1-3
3
, or .
OK
button for five seconds. This sends the Security Code
Send OK!
and you hear a beep when the transfer is
Send Error!
"Assigning the Security Code" on page
.
.
3. Handset ID
.
.
To correct this, repeat steps 9
18. Ensure you enter a
"Changing the