When Programmes Overlap Each Other - JVC 1204MNH-SW-VE Instructions Manual

TIMER RECORDING ON VHS DECK
56
EN
VHS
CANCEL
ENTER
VHS#
Check, Cancel And Change Programmes
1
When the VHS recording lamp (R) lights up on the unit
Press VHSj, then press DVD A.
When the VHS lamp does not light up on the unit
Press VHS so that the VHS lamp lights up on the unit.
2
Press PROGRAMME to access
the Programme screen.
3
Press F G to select
APROGRAMME/CONFIRMB,
then press ENTER to access the
Programme Check screen.
4
Press F G to select the
programme, then press ENTER.
The programme screen appears.
To cancel a programme
Press CANCEL.
5
Change the settings of the desired recording options as
required.
●
Refer to steps 6 – 12 in AManual Timer ProgrammingB
(A pg. 55).
6
Press PROGRAMME to complete timer correction. The
previous screen resumes.
7
Press VHSj.
●
The VHS recording lamp lights up on the unit and the HDD or
DVD deck is automatically selected. When the HDD or DVD
deck is in timer standby mode, the unit is automatically turned
off.
CABLE/SAT
TV DVD
1
PROGRAMME
rtwe
DATE START STOP
CH
[JK]N[ENTER]
[PROGRAMME] : EXIT
DATE START STOP
TV PROG
DAILY/WEEKLY
MON-FRI
ARD
SP/LP VPS/PDC
SP OFF
CURSOR : [HI] SELECT : [JK]
CONFIRM : [ENTER]

When Programmes Overlap Each Other

If APROGRAM OVERLAPPEDB appears, you have another
programme overlapping the programme you have just made.
The Programme Check screen appears and conflicting
programmes will start blinking.
PROGRAM OVERLAPPED
Example: Programme 1 (you have just made) and Programme
4 overlap each other.
1
Confirm the overlapping programmes. Overlapping
programmes blink on the TV screen.
2
Press F G to select the programme to modify, then press
ENTER or E.
●
You can only select one of the overlapping programmes.
NOTE:
If you do not mind this overlap, press PROGRAMME to finish the
timer programme setting. The programme with the lower
programme number will be recorded and the other one will not be
recorded correctly. If no changes are made for approximately 1
minute, the unit will return to the normal screen.
3
Press F G to select the desired programme to be cancelled or
changed.
To cancel the programme
Press CANCEL.
●
APROGRAM COMPLETEDB appears on the TV screen for about
5 seconds, then the normal screen resumes.
To change the programme setting
Press ENTER, then go to step 4.
4
Change the programme setting.
●
Refer to steps 6 – 12 in AManual Timer ProgrammingB
(A pg. 55).
5
Press PROGRAMME to access the Programme screen, then
press F G to select APROGRAMME/CONFIRMB to check if the
conflict has been settled.
Programme check screen appears.
●
APROGRAM COMPLETEDB appears on the TV screen for
about 5 seconds, then the normal screen resumes.
6
Press VHSj.
NOTE:
When any overlaps remain after deletion and modification of
programmes, Programme Check screen remains showing the
conflicting programmes. In such a case, repeat the procedure
above until the conflict is solved.
DATE START STOP CH
DAILY
[JK] N [ENTER]
[PROGRAMME] : EXIT